免费看一级黄色录像,成年人黄色片视频,中文字幕在线播

首先應提供油水分離器及15ppm油份報警裝置OMD11的相關證書

1. 臨時污油桶內準備污油水, 供試驗油份計使用;

2. 確認電機的轉向無誤, 測量泵的驅動電機冷/熱絕緣電阻應不小1MΩ;

5. 打開下部沖洗水入口的氣動活塞閥和上部分離油的出口閥,由下部進入沖洗水, 上部出油口排氣,當水注滿后各閥關閉,三色兩極管為綠色,排水泵起動,上部三通閥排水;確認壓縮空氣的壓力為6~8bar, 供水壓力為最大1bar;

6. 油份探測器試驗(可模擬進行, 三色兩極管顯示)

接通電加熱器. 當探測器從水中浸入到油或空氣中, 三色兩極管顯示紅色,裝置上部排油閥打開,排油到艙柜;重新浸入水中, 三色兩極管顯示為橙黃色(或者閃亮,為反沖洗)上部反沖洗水出口閥打開, 油排出閥關閉.泵停止,同時停止加熱;

拆下報警器水樣進出口管,進口接自試驗用污油水,進行報警試驗;

當分離水含油小于15ppm,排舷外;當大于或等于15ppm時,排舷外口自動關閉,轉換為排艙底水艙;

運行分離器30分鐘, 分離器連續操作兩個分離循環, 依靠時間的設定從油注入到油渣排出口;

FIRST SUPPLY CORRELATION CERTIFICATE FOR RWO OIL WATER SEPARATOR &FOR 15ppm ALARM MONITOR

2. CHECK THE DIRECTION OF MOTOR ROTATION. MEASURE THEISOLATION RESISTANCE OF MOTOR PUMP IN COLD AND HOT CONDITION. THE VALUE IS NOTTO BE LESS THAN 1MΩ;

3. TEST SAFETY VALVE OF SEPARATOR. THE SETTING PRESSURE: P=0.20+0.01Mpa;

5. OPEN THE PNEUMATIC PISTON VALVE OF FLUSHING WATERINLET AND THE VALVE OF OIL OUTLET. FILL FLUSHINGWATER, VENTILATE AIR FROM OIL OUTLET. WHEN FLUSHINGWATER IS FULL, THE DIODE IS GREEN AND THE DISCHARGE WATER FROM UPPER THREE-WAY VALVE; ENSURE COMPRESSED AIR SUPPLY ARE 6~8bar,WATER SUPPLY IS MAX 1bar.

THE HEATER WORK, WHEN SENSORIS DIPPED INTO OIL OR AIR, THE DIODE IS RED, THE VALVE OF DISCHARGING OIL ANDDISCHARGE OIL TO BILGE TANK. WHEN SENSOR IS DIPPED INTO WATER, THE DIODE IS ORANGE, THE VALVE FOR FLUSHINGWATER OUTLET OPEN, THE VALVE FOR DISCHARGE OIL IS CLOSED. THE PUMP AND HEATERSTOP.

WHEN THE OIL CONTENT OF THETREATED WATER ＜15PPM, IT IS DISCHARGED OUTBOARD, WHEN THE OIL CONTENT OF THE TREATEDWATER≥15PPM, IT ISDISCHARGED TO BILGE TANK.

THE SEPARATOR TO OPERATEDFOR 30min--- SEPARATOR TO OPERATE TWO CONSECUTIVE PURIFYING CIRCULATION, FROMOIL FILLING IN TO SLUDGE DISCHARGING OUT, DEPEND ON TIME SETTING..

影视先锋中文字幕_国产精品久久久久电影_亚洲在线日韩_欧美精品在线免费观看

油氣儲運網